Owner's Manual

IN AN EMERGENCY
201
CHANGING A WHEEL
Please be informed that:
– the jack mass is 2.100 kg.
– the jack requires no adjustment.
– the jack cannot be repaired. In the
event of breakage, it must be replaced by
another original one.
– no tools other than its operating crank
can be fitted to the jack.
To change a wheel, proceed as follows:
– Stop the car in such a position that it is
not dangerous for the traffic, where it is pos-
sible to change the wheel safely. Where pos-
sible, park on a level, compact surface.
– Switch off the engine and engage the
handbrake.
– Engage first gear or reverse.
– Use the handle (A) to remove the piece
of stiff cover (B).
– Loosen the clamping device (A-fig.
3).
– Take out the tool container (B) and take
it near the wheel to be changed.
– Take the spare wheel (C).
– Remove the wheel cap (A-fig. 4) (on-
ly versions with steel rims)
– Using the wrench provided (A-fig.
5), loosen the fastening bolts by about
one turn.
– Set the jack under the car, near the
wheel to be changed taking care not to dam-
age the plastic streamlined guard.
– Work the jack crank (A-fig. 6), to
extend it until the groove (B) on the
upper part of jack is correctly inserted on the
lower profile of the body (C) approx. 40 cm
from the profile of the wheelhouse.
– Work the jack and raise the car until
the wheel is a few centimetres from the
ground.
fig. 2
A0A0150m
fig. 3
A0A0151m
fig. 4
A0A1059m
197-233_Alfa147 Q2 GB 4-07-2008 12:04 Pagina 201