Operation Manual

9
v
b
z
x
c
n
Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its
highest position by turning the handwheel
counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread
coming off as shown.
z Draw the end of thread around the upper
thread guide.
c Firmly draw the thread up and from right
to left over the take-up lever then down
into the take-up lever eye.
x While holding the thread near the spool,
draw the end of the thread down around
the check spring holder.
v Then draw the thread down and slip it into
the lower thread guide.
b Draw the thread down and slip it into
needle bar thread guide on the left.
n Thread the needle eye from front to back.
z
x
c
v b n