Datasheet

ALFACHARGE WIRELESS CHARGER AL3-V
12/24VDC WIRELESS CHARGER MODULE
THE RANGE
The Alfacharge range has been designed to meet the rigorous standards required for on
board commercial vehicle applications including EN50498 and ISO7637-2 and is both
CE and E marked (Reg10). The casings are made from V0-rated (self-extinguishing)
high impact polycarbonate and the PCB is populated by computer-controlled SMT for
maximum accuracy and durability.
Designed for integration into
passenger vehicles.
Accepts both 12Vdc and 24Vdc.
• Approved to EN50498 and
ISO7637-2. E marked
(Reg10) and CE marked.
• Phone communicates every
millisecond to establish
correct charge.
• Foreign object detection &
activation.
• Convenient wide input of
9-32Vdc in one standard
casing.
• LED to confirm correct
operation.
WARRANTY
The AL3 Series of wireless chargers
are manufactured using rugged
components to provide years of
service in demanding commercial
environments and are covered by a
three year return to base warranty.
PASSENGER ACCESSIBLE WIRELESS CHARGERS FOR
VEHICLE INSTALLATIONS
Wireless charging is increasingly becoming the preferred method of maintaining battery
power in mobile devices, with most of the latest designs from the major manufacturers
including wireless charging as standard.
The AL3-V wireless charger is designed for installation into table tops on vehicles such
as buses and coaches to allow passengers the ability to charge their devices on the
move. The unit is installed through an 80.0mm hole in the table and secured
underneath, providing an unobtrusive and functional enhancement of the passenger
experience. These units make a complementary addition to the AL1-H integrated
charger modules, and can be installed at the vehicle build stage or as part of a retrofit
activity, as required.
The wireless receiver of the charging unit will automatically detect the presence of
suitably enabled mobile devices and will typically charge through a case up to 3.0mm
thick.
Alfatronix wireless charging
module AL3-V
The wireless charging unit can be easily installed through an
Ø80.0mm hole in any flat surface. Cables are secured by the
retaining plates completing the installation.
Charging coil centre.
Cover plate grips
and secures wires
into position.
Tabletop
min. 19.5mm
max. 50.0mm
Mobile phones with cases
up to 3.0mm thick will
normally charge
successfully.
It is recommended that these
units are fused individually with
a 1Amp fuse (24V systems) or
a 2Amp fuse (12V Systems).
Suitable in-line fuses are
available;
Part Numbers:
PVP-FUSE 1, PVP-FUSE 2