Use and Care Manual

Solid Surface Resin Tub Maintenance Tips
Please follow our maintenance tips below for proper care of your tub.
Routine Care & Cleaning:
Avoid long term damage by properly cleaning the tub on a regular basis. This will
help lengthen the life of the tub, as well as ensure that the tub remains hygienic and
safe for use.
We recommend using water and soap for routine cleaning. Ammonia detergent or
bleach are also allowed, if necessary. While cleaning, in a circular motion, try not to
extend the stained area, only apply the cleaning solution to the necessary area, then
quickly rinse with warm water and wipe clean.
For stubborn stains use a soft cloth or sponge (nonmetal!) with a mild cleaning
solution. Always clean in a circular motion.
Most stains can easily be wiped away with water alone. These include stains as a
result of: Household Soaps, Hydrogen Peroxide, Nail Polish Remover, Oils, Shoe
Polish, Synthetic Detergent. Other stains might require a cleaning solution, ammonia,
or bleach. These include stains as a result of: Cosmetics, Crayons, Eye Shadow,
Hair Coloring Agents, Oil Ink, bath bombs, and bath salts.
Routine Maintenance:
Damage Caused by Heat: Although ALFI brand Resin Tubs are made to withstand
very high temperatures, direct contact with hot metals, such as hot irons, or curling
irons, will damage the resin surface. To ensure the surface is protected, please do
not allow direct contact of any material other than; hot water, soft heating
pads/towels, and sponges. Temperatures higher than 170ºF are not recommended
and can damage the tub.
If small scratches appear you may use 220 grit sandpaper (fine) to lightly sand the
necessary area in a circular motion until smooth again and scratch disappears.
Immediately follow with soap and warm water, rinse, and wipe clean.
www.ALFIbrand.com 323-732-4045 [e-mail]