Installation & Assembly

PARTS LIST:
A. Place at side of Fixing Board ush and leveled with the wall (Note: The edge with 3 holes should be up). The
recommended height from the bottom of the Fixing Board to the oor is 15 1/2” - 19 1/2 “. Mark the location of the
screw holes on the wall and remove the Fixing Board so as to drill 5 holes with a depth of about 2 1/2”. Insert anchors
into holes. (Figure A)
B. Screw the Fixing Board into the wall and tighten. (Figure B)
C. Align the main body of the Shower Seat with the Fixing Board on the wall. (Figure C)
D. Use the supplied Allen key to tighten the 2 Allen screws already attached to the underside of the main body of the
Shower Seat. (Figure D)
STEP BY STEP INSTALLATION:
When properly installed, the maximum safe loading weight on this seat is 300 lbs.
IMPORTANT:
Before installing, please read the instructions carefully
in order to install and use this product safely.
ABS14
Los Angeles, CA Tel: [phone] www.albrand.com
Main body of Shower Seat
2.4" Screws and Anchors
Fixing Board
2 x 0.4" Allen Screws
ABS14
SHOWER SEAT INSTALLATION INSTRUCTIONS
A B C D