User's Manual

2.2 Fit the Pet Collar Unit on your Dog’s Neck
IMPORTANT
For effective and reliable operation of the PBT-100, the Pet Collar Unit must be
properly placed and fitted on your dog’s neck with suitable Metal Contacts that are long
enough to touch the dog’s skin on the underside of its neck (not its hair).
1. Make sure that the Pet Collar Unit is powered off.
Press and hold the
POWER KEY to power it off.
2. Have your dog stand in a balanced position on a flat even surface.
3. Put the strap around your dog’s neck, measure the proper strap length for your dog.
4. Adjust the length of strap according previous measuring.
5. Put the strap over your dog’s neck, centering the Pet Collar Unit underneath its neck
and making sure that the logo is upright facing you.
6. Try to buckle up the strap. If the tightness is not well, buckle down it, adjust the strap
length again.
7. Check to ensure that the Pet Collar Unit is in the center underneath the neck of your
dog.
8. Check the fit again after your dog has worn the Pet Collar Unit for several minutes or as
your dog gets more comfortable with it.
NOTE
The Pet Collar Unit should fit snugly on your dog’s neck such that you can only fit two
fingers underneath it. It should not be able to rotate around the neck. If necessary, trim
some of your dog’s hair where the Pet Collar Unit makes contact with the skin to allow for
consistent performance.