User's Manual

3.3 Work on bark control mode
Enter bark control mode
Press and hold the POWER KEY for 1 seconds on the Collar Unit to power it on. The Indicator
LED will lights up for 3 seconds. If current mode is not bark control mode (the color of power
led is not green), hold MODE key for 1 seconds to enter bark control mode.
When the
collar just enter bark control mode, there are 30 seconds named
setting time for setting correction level for it, during which,
the green led flash once per 1 seconds, and the collar can accept
correction level setting and mode select signal from remote unit.
If the 30 seconds expired, the collar start to work normally, the green led flashes once per 5
seconds and the collar can’t be controlled by remote unit any more.
Set correction level for bark control mode
If the screen of remote unit is closed, press any key to wake up it, and then hold MODE key for
1 second to select bark control mode on remote side.
You can only set the bark control correction level when the collar unit is within the setting time,
which is first 30 seconds after enter bark control mode.
Press Add/Sub key to change correction level you wanted showed on screen, and then hold
SHOCK KEY for 3 seconds to confirm the setting. The collar unit will beep on success setting it.
The setting would be stored, and be remained although the battery has been removed.
Trigger
When a dog bark detected, then the collar is triggered, the indicator LED on collar will display
red and green alternately, the correction signal, beep tone or electric shock is delivered at the
same time, which depends on the predefined train routine (see page 4)
"Free" Bark Duration
Your dog is allowed five seconds of "free" barking time, during which just warning beep will
trigger. Should your dog continue to bark, the Pet Collar Unit will administer a static
correction at the level that you have selected.