Troubleshooting Guide

English 13
Connection to the water line
ATTENTION
Hose coupling with aquastop on the
water connection of the device
Damage to the pump
Never use a hose coupling with aquas-
top on the water connection of the de-
vice.
You can use an aquastop coupling on
the tap.
1. Screw the supplied hose coupling
on to the end of your garden hose.
2. Attach the garden hose to the cou-
pling for the water connection.
3. Connect the garden hose to the wa-
ter line.
4. Open the water tap completely.
Suck water from open containers
This high-pressure cleaner is equipped
with the KÄRCHER suction hose with
check valve (special accessory, order
no. 2.643-100) is suitable for sucking in
surface water, e.g. from water butts or
ponds (for maximum suction height,
see chapter Technical data).
In suction operation, the coupling for
the water connection is not required.
1. Fill the suction hose with water.
2. Screw the suction hose onto the wa-
ter connection of the device and
hang it in a water source (e.g. water
butt).
Vent the device
1. Switch on the device “I/ON”.
2. Unlock the lever of the high-pres-
sure gun.
3. Press the lever of the high-pressure
gun.
The device switches on.
4. Let the device run for a maximum of
2 minutes until the water comes out
of the high-pressure gun without
bubbles.
5. Release the lever of the high-pres-
sure gun.
6. Lock the lever of the high-pressure
gun.