Troubleshooting Guide

20 English
No pressure indicator on the high-
pressure gun
1. Carry out the pairing to the high-
pressure cleaner again, see chapter
.
Error messages
1. Switch off the device "0/OFF".
2. Pull the mains plug out of the outlet.
3. After 20 seconds, reinsert the mains
plug into the socket.
4. Switch on the device “I/ON”.
If the malfunction occurs several
times, have the device checked by
Customer Service.
Emergency run
If there is a defect in the pressure reg-
ulation on the high-pressure gun, the
high-pressure cleaner will operate at
maximum level.
1. Deactivating the emergency run:
a Switch off the device "0/OFF".
b Pull the mains plug out of the out-
let.
c After 20 seconds, reinsert the
mains plug into the socket.
d Switch on the device “I/ON”.
If the malfunction occurs several
times, have the device checked by
Customer Service.
High-pressure gun does not work
properly
An internal fault has occurred in the
electronics of the high-pressure gun.
1. Press the locking slide.
2. Open the battery compartment.
3. Remove the battery.
4. Insert the batteries, making sure the
poles are oriented correctly.
5. Close the battery compartment.
If the malfunction occurs several
times, have the device checked by
Customer Service.