Alfred Installation guide ETE Alfred International Inc. reserves all rights for the final interpretation of the following instructions. A\ All design and specifications are subject to change without notice EN VER 9.
Outside escutcheon Inside escutcheon Touch scream keypad Battery cover BoM boo ‘Status Indoctrinated) 26 Status Indleator(Grasn) 1 pe Status indicator(Battery) 3 Cylinder ) N—— Reset button Thumb turn Status Indicators 1#. Unlocked, or setting succeed. 2#. Locked, or setting failed. 3#.
THIS SDE AGAINST DOOR Outside escutcheon Latch bolt Strike plate Inside escutcheon Reinforcement Plate 2/6 Battery cover X4 AA alkaline battery I x KA4*40 — #8 32*30 x2 x1 BM4*§ KM4*6 x2 KA4*20 x1 Optional 3rd Post May come per-installed on Lack, can ba removed with pullers x1 Rotation shaft x2 Override key Screw pack
Tools Needed Lock Installation #2 Philips screwdriver BTA MN T Door prep (Optional Tools, only required if installing lock on new The handing switch sends to be put in the door without existing Lock Prep)) direction the latch bolt is sliding when 1. 53mm hole saw looking at the inside of your door. 2.17 26mm boring bit 2.5mm drill bit 10mm drill bit 5. Chisel&Hammer PREPARE LOCK FOR INSTALLATION Unpack the Lock A. Inside escutcheon Confirm door handing direction.
Installation A NOTE: Make aura to allow for the bolt to be centered In the strike. Make sure that the arrow at the tail end is pointing upwards. NOTE: The bolt must be in retracted{Unlocked) position when Installing the locket. @I Th xan @hr—— X2KA4+20 The 3rd Top Post is OPTIONAL. The Top Frost is used for additional security, or when a door Is weak or warped. The Top Post can be easily removed by unscrewing with a pair of pliers and discarded.
Installation NOTE: 3rd Post on Top is OPTIONAL. 48-32430 /I\NOTE: Do not over-tighten. PCB compactor Cable connector NOTE: Tail piece must ba in the horizontal position when properly installed.
Installation NOTE: The horizontal orientation of the tailpiece as you insert the inside escutcheon(thumb turn should be vertical} 6/6 X2 BM4*s X1 KM4*6 NOTE: Test operation using thumb turn before installing batteries to make sure latch bolt extends smoothly. If latch bolt does not extend, please check that the tail piece was inserted correctly. Congratulations, you have in: d the Alfred DB1 Touch Screen Smart Deadbolt.
Download the Alfred Home App Alfred Home Download on the & i Sie Bi i For support, please reach out to: You can also reach us at 1-833-4-ALFRED (253733) www.alfredinc.