Alfred DB2 Installation guide Alfred International Inc. reserves all rights for the final interpretation of the following instructions. A\ All design and specifications are subject to change without notice ENVELOPER
Outside escutcheon Status indicator 1# Inside escutcheon Bs Status indicator 2# Battery Touch screen keypad 0 pm Wireless module dl Reset button socket 2 Speaker Status indicator 3# Thumb turn oO Multi-functional Nr Status Indicators 1#. Door secured 2#. Door unlocked 3#.
X4 AA alkaline battery THIS SDE AGAINST DOOR Battery cover I x KA4*40 32*30 Outside = escutcheon Mounting plate Inside escutcheon BM4*6 Kmart x2 x1 KA4*20 Rotation shaft with key tailpiece x1 Optional 3rd Post May come per-installed on Lack, can ba removed with pullers Latch bolt Strike plate Reinforcement Plate Screw pack 2/6
Tools Needed Lock Installation #2 Philips screwdriver BTA MN T Door prep (Optional Tools, only required if installing lock on new The handing switch sends to be put in the door without existing Lock Prep)) direction the latch bolt is sliding when 1. 53mm hole saw looking at the inside of your door. 2.17 26mm boring bit 2.5mm drill bit 10mm drill bit 5. Chisel&Hammer PREPARE LOCK FOR INSTALLATION Unpack the Lock A. Inside escutcheon Confirm door handing direction.
Installation A NOTE: Make aura to allow for the bolt to be centered In the strike. Make sure that the arrow at the tail end is pointing upwards. NOTE: The bolt must be in retracted{Unlocked) position when Installing the locket. X2KA4*20 — X4 KA4*40 The 3rd Top Post is OPTIONAL. The Top Frost is used for additional security, or when a door Is weak or warped. The Top Post can be easily removed by unscrewing with a pair of pliers and discarded.
Installation Lad NOTE: 3rd Post on Top is OPTIONAL. PCB connector Cable connector NOTE: Tail piece must ba in the horizontal position when properly installed.
Installation NOTE: The horizontal orientation of the tailpiece as you insert the inside escutcheon(thumb turn should be vertical} NOTE: Test operation using thumb turn before installing batteries to make sure latch bolt extends smoothly. If latch bolt does not extend, please chock that the tail piece was Inserted correctly.
Congratulations, you have installed the Alfred DB2 Touch Screen Smart Deadbolt. Please now download the Alfred Home App from either the Apple App Store or Google Play Store to set up your Master PIN Code for the lock or refer to Programming Instructions booklet provided. Download the Alfred Home App Alfred Home PETITION LEE ETE TY RNR Ge For support, please reach out to: You can also reach us at 1-833-4-ALFRED (253733) www.alfredinc.