Use and Care Manual

6
ASSEMBLY
2
Hardware: O Bolt (6x18mm) x3
P Washer (6mm) x3
Hardware:
L Stud (8x30mm) x 4
M Washer/Spring Washer/Nut (8mm) x 4
U Plastic Cap x 4
2
3
U
M
L
3
3
Place Table Top C upside-down on a non-abrasive surface.
Screw 4 Studs L into the holes on the Table Top using
Screwdriver T. Then carefully place the upside-down fire pit
base on the Table Top and align the holes in the top of the
Legs with the Studs previously installed in the Table Top.
Place the holes over the Studs and secure each corner with
Washer/Spring Washer/Nut M as illustrated. Tighten with
Wrench R. Then place
Plastic Caps U over Nuts.
WARNING:
This fire pit is constructed of aluminum, a
relatively soft, flexible metal. Never sit,
stand, or lean heavily on the top of the fire
pit, which can cause bending or warping.
Door
Hole away from door
Hole away from door
Hole near door
Hole near door
O
P
Once all Panels are bolted together, carefully turn the table
base upside-down. Attach Gas Tank Support G to Side
Panels E by aligning holes in Gas Tank Support with holes
in the bottom of Side Panels and Door shown in figure 2 .
Insert Bolt O through Washer P into holes and tighten with
Hex Key/Wrench S.