Instructions / Assembly

CAUTION: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING: Do not use this appliance if any part has been under water. Immediately call a qualied service technician
to inspect the appliance and to replace any part of control system and any gas control, which has been under water.
OPERATION
SAFETY WARNINGS
1. Never leave the Fire Pit unattended during operation.
2. Clothing or other ammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualied service person. The appliance should be inspected before
use and at least annually by a qualied service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause sever burns if contacted.
2. Do not burn any solid fuels in this appliance.
INITIAL START UP
1. Turn gas ON. Ensure you have leak tested the re pit before operating.
2. Press the ON button on the handheld transmitter. You will hear the ignitor probe sparking, light the gas and fre
pit will come on. WARNING: Do not stand over Fire Pit during ignition or operation due to high surface tempera
tures.
Put the gas tank in the metal stand. Make sure the gas tank sits on the metal stand completely.
Turn the wing screw on the outer part of the metal stand clockwise to ensure the gas tank tightly.
The distance between fireplace built-in stage and LP cylinder must be over 60 inches.(as the picture shows)