Assembly instructions AFH#55-1341Triora 23.
NO Parts A B Figure Qty NO Parts Figure Qty Table top 1 G Bolt(6*32MM) 6 Leg 3 H Washer,Spring washer, Nut(8MM) 23 6 C Round leg support 1 I Washer,Spring washer, Nut (6mm) D Backrest 2 J Screw (8*32MM) 3 E Seat 2 K Wrench 1 F Chair leg 8 L Screwdriver 1 2
Chair Assembiy lnstruction 1. Fit the Backrest(D)to the Seat(E)by inserting the prefixed studs into the two holes on the seat. Bolt together using Washers,Spring washers, Nuts(H).Tighten the nut using the Wrench(K). H x4 2. Turn the unit upside down. Fix the Chair legs(F)to the Seat(E)by fitting the prefixed studs and into the holes in the top of the legs.Bolt together using Washers,Spring washers andNuts(H).Tighten the nut using the Wrench(K).
Table Assembly lnstruction 1. Lay the table top(A) upside down on an even soft clean surface.Fix the screw(J)into the table top,then fit the three table legs(B)over the fixed studs(J)and bolt in position using washers,Spring washers,and nuts(H).DO NOT OVER TIGHTEN. HX3 J x3 2.Attach the round leg support(C)to the three legs using Bolts(G), washers,Spring washers, and nuts(I)Tighten all nuts.
To comply with the requirements of California Proposition 65, this product carries the following warning: WARNING:This product contains chemicals known to the State of California to cause cancer,birth defects or other reproductive harm.