Use and Care Manual

ASSEMBLY INSTRUCTIONS

6. Connect hose and regulator to cylinder.

The propane gas and cylind er are sold separately.

Use a standard 20 lb. propane cylinder only.

Use this heater onl y with a propane vapor withdrawal

supply system. See chapter 5 of the standard for

storage and handling of liquefied petroleum gas,

ANSI/NFPA 58. Your local library or fire department

should have this b ook.

Storage of an appli ance indoors is permissible only if

the cylinder is dis connected and removed from the

appliance. A cylinder must be stored outdoors in a

well-ventilated are a out of the reach of children. A

disconnected cylinder must hav

e dust caps tightly

installed and must not be stored in a building, garage or

any other enclosed area. The maximum inlet gas supply

pressure: 250 psi, The minimum inlet gas supply

pressure: 5 psi .

The minimum hou rly of 10000 Btu is the required input

rating for a heater for automatic operation at ratings less

than full inputrat ing .

The pressure regulator and hose assembly supplied

with the appliance must be used.

The installation m ust conform with local codes, or in the

absence of local codes,with national fuel gas code,

ANSI Z223.1/NFPA54 , natural gas and propane

Installation Code, CSA B149.1, or propane storage and

handling code, B14 9.2.

Standard 20 lb. tank

Put the Burner Cover (A) on the burner,

when the Fire Pit is NOT in use or after use.