Owner's Manual

1/2” FPT X 1/2” MPT

90° ELBOW

CONVERTIBLE GAS PRESSURE

REGULATOR

TYPICAL

Alfresco

™ ALXE

BBQ (36” MODEL SHOWN)

SHUT OFF HAND VALVE

MUST BE LOCATED IN

ACCESSIBLE AREA

INCOMING NG

GAS SUPPLY

Figure # 3

NG FLEXIBLE

HOSE

NOTE: To ensure proper heating performance of this appliance, verify that the gas line supply pressure

is adequate (7.0” W.C. supply pressure is preferred) to maintain 4.5” W.C. manifold pressure.

Use a minimum 1/2” ID flex hose to prevent gas starvation.

NATURAL GAS CONNECTION:

Ensure that the service pipe supplying the Grill is fitted with a shut off valve conveniently positioned and

easily accessible as an emergency gas shutoff.

Your

Alfresco

™ Gourmet Grill for use with natural gas comes equipped with its own regulator which

MUST NOT be removed.

If this regulator needs to be replaced use only the type specified by

Alfresco

™ Gourmet Grill for this

appliance.

To connect the regulator / hose assembly follow the next steps:

1. Locate the regulator and gas connection point in the rear right side of your BBQ unit (remove the

rear panel from the BBQ cart to gain access - in cart mounted models).

2. Attach a 1/2” FPT x 1/2” MPT (male-to-female) elbow to the regulator (see figure # 3).

3. Fasten the hose connection to a 1/2” MPT x 3/8” COMP (compression flare fitting) connected to

the elbow. (see figure # 3).

Connect flare fitting to gas supply using a 1/2” Ø minimum flexible (semi–rigid) stainless steel gas hose,

no more than 48” in length. The hose as well as the connectors must comply with the Standard for Con-

nectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 • CAS 6.27.