Owner's Manual

! WARNING

KEEP ANY ELECTRICAL CORD

AND FUEL SUPPLY HOSE AWAY

FROM ANY HEATED SURFACES.

LP GAS CONNECTION TO LP TANKS:

Your

Alfresco

™ Gourmet Grill for use with LP gas comes equipped with its own regulator, which

MUST NOT be removed. There is also a secondary high capacity, hose/regulator assembly for connec-

tion to a standard 20 Lb. LP cylinder. The LP gas pressure regulator and hose supplied with this unit

must be used without alteration.

If this assembly needs to be replaced use only the type specified by

Alfresco

™ Gourmet Grill for this

appliance. 30” grills require at minimum, a 90,000 BTUH regulator / hose assembly. All other sizes re-

quire at minimum, a 160,000 BTUH two-stage regulator / hose assembly.

To connect the regulator / hose assembly follow the next steps:

1. Locate the regulator and gas connection point in the rear right side of your BBQ unit (remove

the rear panel from the BBQ cart to gain access - in cart mounted models).

2. Attach a 1/2” FPT x 1/2” MPT (male-to-female) elbow to the regulator (see figure # 2).

3. Fasten the hose connection to a 1/2” MPT x 3/8” COMP (compression flare fitting) connected

to the elbow. (see figure # 2).

1/2” FPT X 3/8” FLARE

BRASS FITTING

CONVERTIBLE GAS PRESSURE

REGULATOR

TYPICAL

Alfresco

™ ALXE

Figure # 2

TYPICAL LP

GAS TANK

LP REGULATOR AND HOSE

ASSEMBLY (PRESET TO 10” WC)

1/2” FPT X 1/2” MPT

90° ELBOW

! AVERTISSEMENT

GARDER TOUT LE CORDON ÉLECTRIQUE ET LE

TUYAU D'ALIMENTATION DE CARBURANT À

L'ÉGARD DE TOUTES SURFACES CHAUF-

FANTES.