Owner's Manual

12
TO TEST:
 Make sure all control valves are in the “OFF” position.
 Apply the soap solution described above to all fittings.
 Turn the gas supply on.
 Check all connections from the supply line, or LP cylinder up to and including the manifold pipe
assembly.
 Soap bubbles will appear where a leak is present.
 If a leak is present, immediately turn off gas supply, tighten any leaking fittings, turn the gas sup-
ply back on, and recheck.
 If you cannot stop a gas leak turn off the gas supply and call your dealer where you purchased
your grill.
 Do not use the grill until all connections have been checked and do not leak.
IMPORTANT NOTE:
ALWAYS CHECK FOR LEAKS AFTER EVERY LP TANK CHANGE.
If a leak is present, or if the connection hose shows signs of wear, these conditions must be corrected
prior to using your grill. If it is evident there is excessive abrasion or wear,or the hose is cut, it must be
replaced prior to the cooking appliance is being put into operation.
The replacement hose assembly is part number:
PROP-KIT-01 which consists of a 36” long hose assembly
with dual in-line regulator and a 3/8” ODF connector.
Contact ALFRESCO™ Grills for replacement.
Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy water
near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
LIGHTING INSTRUCTIONS:
BEFORE LIGHTING…
The pressure regulator and hose assembly supplied with the unit
must be used. Never substitute regulators for those supplied with
the grill. If a replacement is necessary, contact the factory for prop-
er replacement.
Screw the regulator (Type QCC1) into the LP tank. Leak check the
hose and regulator connections with a soap and water solution be-
fore operating as explained on the LEAK TESTING section of this
manual.
GRILL BURNERS LIGHTING:
Turn all knobs to “OFF” then turn on the gas supply.
Always keep your face and body as far away from the grill as possible when lighting. Open the lid, de-
press the igniter button for the burner you are trying to light, and immediately push and turn the burner
control knob counter-clockwise to the “HI” position and wait for the burner to light. (See illustration on
next page)
NOTE: The first burner may take longer to light while air is purged from the gas supply system.
If the burner does not light in 4 seconds, turn knobs to “OFF” and wait 5 minutes to allow any accumulat-
ed gas to dissipate before trying again. If the burner will not light after several attempts, then it can be
lit with a match.
WARNING
HOOD MUST BE OPEN WHEN
LIGHTING GRILL.
HOOD SHOULD NOT BE
CLOSED FOR LONG PERIODS
WHEN IR BURNERS ARE IN USE.
WARNING
DO NOT ATTEMPT TO LIGHT
THE GRILL IF THE ODOR OF
GAS IS PRESENT.