Owner's Manual

FRONT PANEL LED LIGHTING REPLACEMENT: To replace an LED light, simply detach the light assem-

bly rail located at the bottom of the bullnose of the front panel of your Alfresco™ Gourmet Grill. As

shown below: please refer to the following steps :

FINGER PUSH THRU EACH SLOT

INSTALLING A NEW LED LIGHT:

Reconnect the cable for the new assembly and reattach it back into the Grill front panel at a slight angle until it “SNAPS”

into place. Very little effort is required to “SNAP” and lock into place.

Note: All knobs may be temporarily removed to easy LED replacement.

Power up your Alfresco™ Gourmet Grill and verify for the new LED lights operation by turning on the light switch.

BULLNOSE FRONT

PULL OUT AND DOWN AND DROP OFF FROM

PANEL ENSURING TO CAREFULLY PULLOUT

LIGHT ASSEMBLY ALONG WITH CABLE PLUG.

DISCONNECT THE CABLE CONNECTOR AND

COMPLETELY REMOVE LIGHT ASSEMBLY

LED RAIL WITH LIGHTS