PASTE SERIAL NUMBER LABEL IN THIS LOCATION AXE-PZA-BI SERIAL NUMBER LABEL: 2 NOTES:
BUILT IN ENCLOSURE GENERAL BUILDING PROVISIONS: When installing the Alfresco ™ Pizza Oven as a built-in unit, careful consideration to the materials used must be made. As a general rule, the materials and construction methods should be the same as the requirements for an outdoor fireplace while maintaining all local building codes. The image on the right, Figure # 1, shows how the Alfresco ™ Pizza Oven might look like in a built-in configuration.
(Building Provisions cont.) As shown on Figure # 5, the 33” minimum height requirement, is the minimum opening requirement to be able to slide the unit into an already-built non-combustible enclosure. This requirement is not necessary if the non-combustible enclosure is built around the unit with materials such as with brick and mortar.
GAS SUPPLY INSTALLATIONS: Because of the Alfresco ™ Pizza Oven’s unique design, it is possible to install the gas supply (NG or LP) from a place below the unti in addition to the standard back supply location. The oven is constructed with an opening at the bottom heat shield to facilitate connections from below.
