Specifications

Document 90-00067 A Algo Communication Products Ltd [phone]
2014-09-12 4500 Beedie St Burnaby BC Canada V5J 5L2 [e-mail]
Page 10 www.algosolutions.com
Apply a thread locking adhesive and install a ¼-20 eyebolt (not included)
into the threaded nut insert on the top of the speaker housing. Screw the
eye-bolt in completely (3/8”) and use a thread locking adhesive to prevent
the bolt from working itself out.
Suspend the speaker using chain or cable rated to support at least 3 x the
weight of the speaker and preferably capable of supporting 200 lb (91 kg)
loads in case the speaker is used for support while on a ladder. Secure the
cable or chain to the speaker and ceiling or truss properly to ensure a safe
installation.
Wiring exits from the protective cover towards the center of the housing
to be run up the cable or chain and dressed neatly using cable ties.
Web Interface
The 8188 Ceiling Speaker is configurable the using web interface or
provisioning features.
After boot up the blue LED will turn off and the speaker will have
obtained an IP address. If there is no DHCP server the 8188 Ceiling
Speaker will default to the static IP address 192.168.1.111.
Press the reset switch (RST next to the LED) momentarily to hear the
IP address over the speaker. The reset switch will not cause a reset
unless pressed during power up.
The IP address may also be discovered by downloading the Algo
locator tool to find Algo devices on your network:
www.algosolutions.com/locator
Enter the IP address (eg 192.168.1.111) into a browser such as
Google Chrome, Firefox, or Internet Explorer (other than IE9). The
web interface should be visible and the default password will be algo
in lower case letters.
SIP Paging One Speaker
The 8188 Ceiling Speaker can be registered as a third party SIP
extension with a hosted or enterprise Communications Server
supporting 3
rd
party SIP endpoints.
To register the speaker with the SIP server, use the Basic Settings 
SIP tab in the web interface to enter the Communication Server IP