Installation Guide

Hampton Pond Installation Instructions and Care
100 Pinebush Road
Cambridge Ontario Canada
N1R 8J8
1-800-984-9933
www.algreenproducts.com
Please read through all instructions before starting.
Once you have found a place for your Hampton Pond all you need to do is fill it with water and
add the pump. Finding the right spot is easy. The pond can be placed on a deck, patio, balcony or
in the garden. Your pump will require a grounded plug so make sure the pond is in an area where
this is available. Follow the pump instructions for pump assembly.
CARE AND MAINTANCE
With the proper care and maintenance this pond will last a very long time and look more beautiful with each year. Simple steps can be taken
to ensure a long life from your pond. Clean your pump regularly to prevent build up. If your pump stops working, unplug it and take it out of
the pond. Follow the care instructions given in your pump kit box. Keep your pump running 24 hours a day to prevent algae build up.
WINTER CARE
Winterizing this pond is very simple. Drain the pond so that there is only ¼ of the water left. The pump should be removed and cleaned for
the winter month to prevent damage. To clean the pump place it in a solution of 2 parts vinegar and 1 part water and let it run for 15-30
minutes. This will allow any calcium or lime on the pump to be cleared away. When doing this be sure to remove any filtration and fountain
heads as it is not necessary to clean them with the solution. To clean the fountain head and filter simply run under warm water.
WARRANTY
The Hampton Pond Kit carries a 2 year warranty from date of purchase, under normal usage. The warranty does not cover the Filter of the SuperFlo Pump. The warranty
covers manufacturer’s defects only. The warranty does NOT cover neglect, tampering, accidental damage or owners misuse. No liability is assumed with respect to loss or
damage of livestock or personal property irrespective of cause thereof.
ATTENTION: Send dated cash register receipt, with explanation of defect and defective product to Algreen Products Customer Service Department.
Be sure to include return address and phone number.
Place desired fountain head on riser
pushing down until snug.
*Adjust the size of the waterbell by turning
the round piece on top.
Put riser into diverter, pushing down
until the hole is no longer visible.
Some light force may be required.
Attach Riser, Diverter and Fountain
Head to the Pump by Screwing the
Diverter into the threaded hole.
*
Please Note: Do NOT plug in your pump until it is
fully immersed in water. Never run your pump dry!
ASSEMBLING YOUR PUMP
**Adjust The flow of water to your fountain
head by turing the diverter nobs.
**