Owner manual

28
CONTROL SETUP
Control Setup



display.

SETPT SOURCE 


to your controller.




display.
The controller will ignore any set-point
except that of the selected set-point source and it will remember which input is

 refers to a remote




refers to a set-point applied
directly at the controller.



 refers to a remote analog set-







NOTE:IPC

SETPT refers to the set-point. This parameter may be changed using the display
only if FRONT PANELSETPT.


LN-DN
CANCEL SET
LN-UP
MODE
>RS232
FRONT PANEL
ANALOG
LOOP
VAR
ON
AUTO
PID
MAIN
SETPT
SOURCE
SETPT
+0.0