User`s guide

chosen device and no audio will be played on the
computer.
The Reset Channels Before Each Song Play option
sends reset commands to all of the controllers on each
channel to ensure that the playing will start from a fresh
start.
By checking the Send MIDI Pre-Events check-box, all
non-note MIDI events in the MIDI file, such as tempo
changes, program changes, and control messages, that
occur before the playback position of the MIDI file will be
sent before the MIDI notes are sent. This is a very useful
option to have checked when starting a MIDI file from a
position other than its beginning. In such a case, without
this option being enabled, the song tempo and
instrument changes would not be set up properly.
The Send Note O" Commands when Stopped is
another useful feature to have enabled. Without this
option enabled, when stopping a MIDI file, all notes that
are being played will continue to be played, as if “stuck”
on. This is because MIDI works by sending note-on and
note-o" commands and the playback was stopped
before the note-o" commands were issued. By having
the Send Note O" Commands when Stopped option
checked, all notes that are playing will be stopped.
The MIDI program patch starting number may be set in
the MIDI Events group box. MIDI equipment typically
start their program patch numbers from zero internally,
but display the starting number as one. With this option
checked, patch number zero will show up as one in Solo
Performer Show Controller to match the number that the
!!
234 Customizing! Solo Performer Show Controller User’s Guide