User's Manual

READER HARDWARE INSTALLATION AND OPERATION CHAPTER 2

ALR-9890 – RR Hardware Setup Guide

DOC. CONTROL #8102XXX-000 REV A

• Attach Circulator B to panel as shown in picture.

Figure 10- Circulator Assembly

• Place a P-Clip around each hanging cable.

• Measure down a little past the middle of each cable (approx. 7”-8”) and

attach the P-Clip to the panel.

• Make sure the cable is not binding or strained at the circulator

connection.

• Tighten the screws so that the cable inside the P-Clip cannot slide

through.

• Check to make sure all of the connectors are at least hand tight.

• If any of the connectors attached to the circulators have come loose

hand tighten, and then using the 5/16” open end wrench tighten a 1/8

turn only.

• Caution: Do not over tighten connectors!

 Route coax cables from the antennas to the reader according to your

system design specifications and secure them properly.

 Attach the Type N-Female Antenna Lines A and B to the correct antenna

lines.

 Align the connector for each cable with the reader antenna port, push

into the port, and finger-tighten the screw fitting.

5. Connect reader power.

 Install the reader power supply. Be sure it is securely mounted.