User Manual

CHAPTER 2 READER HARDWARE INSTALLATION AND OPERATION
ALR-F800 HARDWARE SETUP GUIDE
DOC. CONTROL #8102141-000 REV A
18
 Mount units individually. Do not stack them.
3. Install the reader.
 Secure the reader through the four mounting holes to its mounting
location (wall, post, mounting bracket) using appropriate M4 pan head
screws less than 4.5 mm long.
4. Install the antenna(s).
 Secure the antenna through the mounting holes on either flange to its
mounting location using appropriate hardware.
5. Connect the antenna(s) to reader.
 Route coax cable from the antenna to the reader according to your
system design specifications and secure it properly. Do not kink the
antenna cable and maintain bend radii of at least 1 inch.
 Align the connector of the cable with the reader antenna port, push into
the port, and finger-tighten the screw fitting.
6. Connect reader power supply.
 If you are using an 802.3af compliant network for reader power skip this
step
 If you are using the PoE power supply, use a short standard Ethernet
cable to connect the reader’s RJ-45 jack to the LAN+DC RJ-45 jack of
the power supply. Align the RJ-45 connector with the corresponding
TCP/IP port on the reader or the power supply and push the connector
in.