User's Manual

CHAPTER 2 BASIC FUNCTIONS
ALH-901X USER’S GUIDE
DOC. CONTROL #8102117-000 REV D
19
Pressing the 0 key at the Boot Menu prompt will leave the bootloader and launch Windows Mobile. The
first boot-up after a firmware upgrade can sometimes take a few seconds longer than usual, as Windows
rebuilds the registry and desktop interface.
[Boot Menu]
1.SD Image Update
2.Clean on Exit (No)
3.Factory Reset
0.Exit
Selection : 1
Connected to Media...!
Completed..!!
Please Cold Reset..!!
[Boot Menu]
1.SD Image Update
2.Clean on Exit (No)
3.Factory Reset
0.Exit
Selection : 3
Are you sure?
(1.Yes or 2.No)
Completed...!
Press the 2 key to enable the Clean on Exit
option (1 to enable, 2 to cancel). The reset
is actually performed when you press 0 to
exit the boot menu. Formatting the unit with
this method returns it to the factory-default
configuration, but leaves the Flash disk
alone.
Press the 3 key to completely clean the
system, including reformatting the Flash
disk. Press 1 to proceed, or 2 to cancel.
You should always do one of these resets
after installing new firmware.
Once complete, you will be prompted to
cold reset the handheld. Press the Power
and Reset keys at the same time, to
perform a cold reset.
Before allowing the unit to boot after a
firmware upgrade, it is a good idea to
perform a Factory Reset on the unit. Do this
by holding down the Fun button immediately
after the cold reset, to re-enter the Boot
Menu.