User's Guide Part 1
CHAPTER 2 INSTALLATION AND OPERATION
NANOSCANNER READER USERGUIDE • DOC ??? 15
© 2003 Alien Technology™
2. Select mounting position for reader.
• Reader should be positioned close enough to the antenna to
accommodate the cable length without putting strain on the connectors.
• Be sure power is available to the selected reader location.
3. Select location for host PC.
• Situate the host PC within 50 ft of the reader in a safe location away from
vehicular and foot traffic.
4. Install reader.
• Secure the reader through the three mounting holes on either flange to
its mounting location (wall, post, mounting bracket) using appropriate
hardware.
• If desired, position the reader so that the LEDs are easily observed.
5. Install antennas.
• Secure each antenna through the mounting holes on either flange to its
mounting location using appropriate hardware.
6. Connect antennas to reader.
• Route coax cables from antennas to reader according to your system
design specifications and secure them properly.
• Align the connector for each cable with the reader antenna port, push
into the port, and finger-tighten screw fitting.
7. Connect reader to host PC.
• Align the RS-232 connector with the corresponding serial port on the
reader and push the connector onto the pins. Finger-tighten the screws
to secure the cable to the reader.
• Align and connect the other end of the RS-232 with the serial port on the
PC.
CAUTION: Antennas must be attached before connecting power to the
reader. Applying power without both antennas connected can damage the
reader.
8. Connect power to the reader.
• Push the power supply connector into the reader port.
• Plug the female end of the power cord into the power supply.
• Plug the male end of the power cord into the 120 VAC outlet.
9. Connect power to the PC.