User's Guide
Table Of Contents
CHAPTER 3 INSTALLATION AND OPERATION
Reader I/O panel
To antenna
Antenna ports (2)
To power supply &
120VAC wall outlet
RS-232 to PC
2. Connect the RS-232 cable to the reader.
• Align the male cable connector so that its shape and pins match the
shape and holes of the female DB-9 serial port.
• Push the aligned connector into the port.
• Finger-tighten the screws to secure the cable/connector to the
reader.
3. Connect the RS-232 cable to the serial port on the PC.
Power supply
connector
RS-232 serial
connector
To power supply To PC
4. Connect the power supply to the reader.
• Using the thin cable attached to power supply, push the connector
into the port until it is securely seated.
NANOSCANNER READER USER GUIDE • DOC # 8101001-000A 22
© 2002 Alien Technology™