User's Guide

CHAPTER 4 READER-ENTERPRISE PROTOCOL

GET READERVERSION

Description: The reader version text can be retrieved using this command.

The resulting text is a multi-line reply. Each line of the reply describes the

version number of a major reader component.

Example

Command

Response

>Get ReaderVersion

>Hardware Version = 1.0.02

Firmware Version = 1.0.01

Software Version = 1.1.22

ET ANTENNALIST

Description: The reader can support the use of multiple antennae. This

command allows the user to select which antenna port(s) to use. If the

antenna is fixed, set this list to just one antenna number. Setting this list to

more than one antenna number will cause the reader to cycle through the list

on each successive tag read. Multiple antennae are specified by passing in a

comma separated list as the argument. An asterisk (*) by a number indicates

the current antenna in a list. The default value is 0. Currently antenna ports 0

and 1 are supported by this reader.

Example

Command

Response

>Get AntennaList

> AntennaList = 0*

>Get AntennaList

> AntennaList = 0, 1*

//Always use antenna 1

>Set AntennaList =1

>OK

//Cycle between antenna 0 and antenna 1

>Set AntennaList =0, 1

>OK

NANOSCANNER READER USER GUIDE • DOC # 8101001-000A 36