Instruction manual

62
9.3.3 Customising Patrols
Patrols can be setup to move the PTZ to different key points and have it stay there for a
set duration before moving on to the next point. The key points are defined by presets,
which can be set following the steps above in Customising Presets.
To set up and use PTZ patrols:
1. Enter the PTZ Control interface, by clicking PTZ in the mouse menu or the
PTZ button on the front panel.
2. Select the Patrol button to enter the Patrol Management menu, shown below.
3. In the Patrol Management menu, you may:
• Configure Patrol:
1. Select a Patrol Number to set.
2. Select valid presets (See Customising Presets) and click the Set button to enter
the Patrol configuration menu. A sequence should have at least 2 valid presets.
3. Set the Key Point No., Duration, and Speed (See below). The Key Point No.
determines the order at which the PTZ will follow while cycling through the
patrol. The Duration refers to the time span to stay at the corresponding key
point. The Speed defines the rate at which the PTZ will move from one key
point to the next.
Intelligent Security and Fire Ltd