L Connections HERE ROE-BLISS Brush less ESC ROE-BLISTER aE Alter Eo (a) RPM Signal Wire Yellow): plug it into the RPM input channel on the sybarites stamen (This wire can provide REM signalization when using textual speed-governing device: (8) BEC Output Wire (Red/Brown): plug it info the battery chandelier or any Undisciplined channel on the receiver.
lH. Throttle Range Calibration HERDER NE 1. The default throttle range of this ESC is from 1100 Us 10 194018, so vou need to re~calibrate the throttle range.on the first time you use this ESC or after you replace the transmitter. 2.During the Radioscopy calibration, please set the throttle curve fo NORMAL and ensure the corresponding throttle amounts to the maximum throttle endpoint and the minimum throttle endpoint on your transmitter are respectively 100% and 0%.
1. Flight Made: 1.1 Airplane Fired Wing: The motorway startup when the throttle amount reaches BY or more: Thea is no soft start-up the motor responds to the thrall increase rapidly. 1.2 Helicopter {Linear Throttle mode = The motor will startup in a:soft way with the throttle {from 010 100% acceleration time js fixed 10.3.5 seconds, The motorway accelerate lo completeness target rev standardization. 1.
5 BEC Voltage From Bio BV (Adjustable) nD av (increments). Default value: §. Startup Time From ds io 28s {Adjustable in 1s Requirement: Default value 158 No let only available in Helicopter (EN Governor) mode and Deli Governor Stare mode function: } 7. Governor Parameter P 1 Control the ESC maintaining the stability of the current motor speed. 8.
Follow above bh Eras OK Bus te don 2] Frisson RIF bunion instruction lo connect ALIGHT AS BOX Multi function fo view over all ALIGN ABBOT Programmed lo the ESC "The informational on oii 5 current firmware version” will the ESC. iB show bn screen for successful mB] Loe battery and ESC. connection. Panda Ean Coma sem age o UNMENTIONABLES | | Egiaimumun maws Be a Notes: The recorded revs are electric revs.
1. Startup Protection | The ESC will monitor ihe motor speed during the startup process. When the speed stops increasing or the sped increase is nol stable enough, the ESC will take ii as a start-up failure. At that time. if the throttle amount is less than 15% the ESC will automatically hy fry fo restart it Up. If the thistles amount is more than 15%. vou need to move the throttle stick back io the bottom position and then restart up the ESC.
