User Manual

5. Basic Operation
37
5
5-6-3 Deleting a memory channel
1
Disable the Write-protect (memory protection) function
(
+
P. ••).
2
Press the key to switch to the Memory mode.
3
Select the channel you want to delete by rotating the
dial.
4
Press the [FUNC] key to display the icon on the LCD.
5
Press the key while the icon is displayed, to delete
the frequency programmed to the memory channel.
CAUTION
• Once data is deleted, it cannot be restored. Check carefully that you
are deleting the right data.
• To prevent important data from being deleted accidentally, be sure to
reactivate the Write-protect (memory protection) function (
+
P. ••) after
deleting data. If you forget to do this, all data in the memory will be
deleted when the "Reset Function" (
+
P. ••) is used.
●
Items which can be programmed to memory channels
The following items can be stored in the memory channels.
• Frequency
• Shift frequency
• Shift direction
• Tone frequency
• Reception mode (Modulation type)
• Tone squelch/Reverse Tone Squelch setting
• Memory name
• Skip setting
MEMO
By using the free software provided by the Alinco website (http://www.
alinco.com/) and the optionally available PC programming cable
(ERW-4C/ERW-7), you can separate each bank of the normal memory
channels as desired (up to 50 banks x desired number of channels less
than 1000 channels).
This function enhancement is possible only via the editing software,
and cannot be operated with the keypad of the receiver.