Installation manual

TEN-TEC
5-Pin DIN Accessory Connector - TGR-SL-CAB5PD
Radio Models
Pin-out
Notes
JP-1
Argonaut V
Jupiter
Omni VII
Pegasus
Check the SLMOD5PD
Jumper Module list
Pin 1 - Mic Input
Pin 2 - GND
Pin 3 - PTT
Pin 4 - AF Output
Pin 5 - NC
The Ten-Tec Jupiter must be in "Line" to use the
ACCY jack (set in radio menu).
TEN-TEC
8-Pin DIN Accessory Connector - TGR-SL-CAB8PD
Radio Models
Pin-out
Notes
JP-1
Eagle
Orion**
Orion II ***
TEN-TEC Delta II Users: Our 8-pin
DIN cable is NOT compatible with
the TEN-TEC Delta II. You must
connect the SignaLink to this radio's
4-pin Mic jack.
Pin 1 - Aux In
Pin 2 - GND
Pin 3 - PTT
Pin 4 - Line Out**
Pin 5 - NC
Pin 6 - Line Out**
Pin 7 - FSK
Pin 8 - NC
**On the original Orion, the "Audio"
menu determines what audio is available
on pins 4 and 6, so the SPKR jumper will
need to be set accordingly.
***On the Orion II, Pin #4 is ALWAYS
the audio output. Can use the
SLMOD5PD Plug & Play per Tigertonics
e-mail of 8June2011
YAESU
4-Pin Round Mic Connector - TGR-SL-CAB4R
Radio Models
Pin-out
Notes
JP-1
FT-7B
FT-101
FT-101ZD
FT-221
FT-227R
FT-901DM
Pin 1 – GND
Pin 2 – Mic Input
Pin 3 – PTT
Pin 4 – N/C
YAESU
8-Pin Round Mic Connector - TGR-SL-CAB8R
Radio Models
Pin-out
Notes
JP-1
FT-1
FT-102/107/107M
FT-290
FT-707/736/736R
FT-747/757
FT-757GX/767GX
FT-840
FT-847**
FT-890**
FT-920**/950**/980**
FT-990**
FT-1000**/1000D**
FT-1000MP**
FT-2000/2200
FTDX5000**
FT-5100
Check the SLMOD8RY
Jumper Module list
Pin 1 – N/C
Pin 2 – N/C
Pin 3 – N/C
Pin 4 – N/C
Pin 5 – N/C
Pin 6 – PTT
Pin 7 – GND
Pin 8 – Mic Input
**On the FT-890, FT-980, FT-990, and the FT-1000
and 1000D, you should also jumper Pin #2 and Pin #5
to Ground.
**On the FT-847, FT-920, FT-950, FT-1000MP and
FTDX5000, you should also jumper Pin #5 to Ground.
Speaker audio is available on some models. Check
your radio manual for availability of these signals and
add the appropriate jumpers.
Check Other Listings for these radios - you may be
able to use the DIN, PACKET, ACCESSORY, or
DATA jack
When using the SLMOD8RY - check jumpers: G1 + G2 installed for: FT-890/980/990/1000/1000D
(picture in section on modules) Only G1 installed for: FT-847/920/950/1000MP