Installation manual

PLUG-N-PLAY MODULES
SLMOD6PM
SLMOD8PD
SLMOD13I
SLMOD13K
SLMODK3
ICOM
IC-207H
IC-208H
IC-2720H
IC-2800
IC-2820
IC-703
IC-706MKIIG
IC-746PRO
IC-7000
IC-7400
IC-910H
KENWOOD
TM-251
TM-271**
TM-271A**
TM-451
TM-D700
TM-D700A
TM-D710
TM-D710A
TM-D710E
TM-G707
TM-733A
TM-V7
TM-V7A,
TM-V71A
TS-480HX
TS-480SAT
**European only
YAESU
FT-100
FT-100D
FT-817
FT-817ND
FT-450
FT-847**
FT-857
FT-897
FT-950
FT-1500M
FT-7100
FT-7800R
FT-8100
FT-8800R
FT-8900R
**Data Port supports
VHF & UHF Packet
only.
ICOM
IC-275A
IC-707
IC-725
IC-728
IC-729
IC-735
IC-736
IC-737
IC-7400
IC-746
IC-746PRO**
IC-756
IC-756PRO
IC-756PROII
IC-756PROIII
IC-761
IC-765
IC-775
IC-775DSP
IC-781
IC-7600
IC-7700
IC-7800
IC-820H
IC-821H
IC-910H
IC-M700PRO
IC-M710
IC-M802
**This jack supports HF
operation only. If you
want to operate both HF
and VHF, then you'll need
to use the 6-pin mini-DIN
Data Port instead.
ICOM
IC-703
IC-706
IC-706MKII
IC-706MKIIG
IC-718
IC-7000**
IC-7200
**This radio does
NOT mute the Mic
jack when using the
13-pin Accy Port, so
we recommend
using the 6-pin Mini
Din Data Port
instead.
NOTE: If your radio is not listed
below, then we recommend trying
jumper setting #1 first, and then
setting #2. You will NOT damage
your radio or the SignaLink if you
use the wrong jumper settings, but
your radio will not transmit properly
(no output power, "hot" Mic, etc.).
==========
Setting #1 - This configuration is
the most common and works with
early Kenwood radios such as the
TS-140, TS-450S,
TS-870 and TS-
950. Some newer
radios such as the
TS-570D, TS-590S, and TS-2000/X
also use this setting.
===========
Setting #2 - This
configuration is
less common and
is used by some
newer radios (TS-690 for example),
and some older radios such as the
TS-440.
===========
Setting #3 - This configuration
works with the TS-940 only.
This jumper module
is compatible with
our rear panel
Elecraft K3 radio
cable only (p/n
SLCABK3 or
SLUSBK3).
SLMODKX3
This jumper module is compatible with our Elecraft KX3 radio cable only