Instruction Manual

5
2
Initial Installation
External Speaker
If you plan to use an external speaker, choose a speaker with an
impedance of 8Ω. The external speaker jack accepts a Φ3.5mm (1/8")
mono (2-conductor) plug.
After being connected to an appropreate power source, press
PWR
key
to turn on. Press and hold
P3
key for 2 seconds to display the supplied
voltage.
The display immediately changes as the voltage supply changes, It also
displays voltage during transmission.
The transceiver will return to its normal operation when the power is
turned ON/OFF or repeat above operation.
Before operating, install an efcient, well-tuned antenna. The success of
your communication will depend on the type of antenna and its correct
installation.
Use a 50Ω impedance antenna and low-loss coaxial feed-line that
has a characteristic impedance of 50Ω, to match the transceiver input
impedance. Coupling the antenna to the transceiver via feed-lines having
an impedance other than 50Ω reduces the efficiency of the antenna
system and can cause interference to nearby televisions, radio receivers
and other electronic equipment.
The range of displayed voltage is from 9V to16V DC. Because the
displayed value is estimated, please use a voltmeter when a more
precise reading is desired.
Power supply voltage Display
Antenna Connection
Accessories Connections
Important
Transmitting without rst connecting an antenna or other unmatched
load may damage the transceiver. Always connect the antenna to the
transceiver before transmitting.
All xed stations should be equipped with a lightning arrester to reduce
the risk of re, electric shock, and transceiver damage.