Instruction Manual

27
11
Key
Combination
Short press
Hold for over 2
seconds
FUNC+
FUNC
"F" is indicated. Goes to setting menu --
P1
V/M SCAN
MW(Setting memory
channel data)
P2
MHz Frequency Offset
Deleting memory
channel
P3
TS/DCS
Power voltage
monitor
Keypad lockout
P4
CALL -- High/Middle/Low power
Key Function
Trouble Shooting
Problem Possible Causes and Potential Solutions
(a)
Power is on, nothing
appears on Display.
+ and - polarities of power connection are
reversed. Connect red lead to plus
terminal and black lead to minus terminal of
DC power supply.
(b)
Fuse is blown.
Check and solve problem resulting in blown
fuse and replace fuse with a new one.
(c)
Display is too dim. Set the LCD backlight parameter properly.
(d)
No sound comes from
speaker.
• Squelch level too hight. Decrease squelch level.
• Selective-calling like TSQ activated. Press
Micro's
key to monitor.
(e)
Key and Dial do not
function.
Key-lock function is activated. Cancel Key-lock
function.
(i)
Rotating Dial will not
change memory channel.
Transceiver is in CALL mode. Press
.
(g)
PTT key is pressed but
doesn't transmit.
• Microphone connection is poor. Connect
microphone properly.
• Antenna connection is poor. Connect antenna
properly.
Maintenance
The function of key combinations can be changed by PC software.
Below is the default setting.
Please contact your dealer when a technical assistance may be
necessary.