ALX B10 ETH Wi-Fi Bridge User Manual
Product brief: Alinket ALXB10 is a bridge device which can help end user to realize the basic function, for example: transmit data from Ethernet port to Wi-Fi port. Its “plug play” function can help end user to connect their devices to Internet through Wi-Fi but don’t need any modification on hardware.
Appearance Network topology:
Indicator detail: Indicator D1: Power Indicator D2: Network Indicator State Explanation Green light is always on B10 power on Green light is off B10 power off Red light is blinking B10 is waiting for network configuration (Flashlink process) B10 has already receive the network config information from Flashlink and start to check RJ45 connection between B10 and customer device, if B10 hasn’t be connected to customer’s device by RJ45 cable, indicator lights are red and blue flashing alternately.
How to connect your device to wireless AP or wireless router: When ALXB10 is used for the first time, it will automatically enter the flashlink network config mode after power-on. The work state can be identified by the red indicator flashing on the device shell. Before network config, please make sure that B10 has been connected to the Ethernet equipment through the network cable. Android： 1) Install flashlink APP to your device and then connect your phone to Wi-Fi.（In this sample, Wi-Fi SSID=A.O.
4) Click the name of device and then click“Select the device and active it” button to start config network for B10. The background will turn green after config is successful, and will turn yellow if config is failed. After network configuration is successful, please make sure again that B10 has been connected to ETH device by RJ45 network cable. At this moment, the red light will go out, the blue light will start to flicker, and finally the blue light will be always on.
IOS： 1) Install flashlink APP to your device and then connect your phone to Wi-Fi； 2) Click Flashlink, see screenshot as below left； 3) Click “Switch to other Wi-Fi” button, select SSID which begin with AFKXXXX then connect to it，see screenshot as below right;
4) Input value of SSID/ Wi-Fi password/Wi-Fi security and use the default setting of Server URL*，then click “Config” button，B10 will try to join appointed Wi-Fi network.
FAQ No. Phenomenon Solution Please check if B10 has been After the red light goes out, the red and 1 connected to ETH device by blue lights flicker alternately. RJ45 network cable. 1. Please check Wi-Fi password/security and After the red light goes out, the blue encryption type setting on light is in a blinking state for quite a flashlink APP. 2 long time. It can't be always on, even 2. Long press reset key of B10 after the reboot it. and re-config network information for it.
Technical support Alinket Electronic Technology (Shanghai) Co.,Ltd。 Mail：sales@alinket.com Tel：+86 21 6104 8124 Addr：Room 702-705, No.
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
