User's Manual

ALXC2X USER MANUAL
Alinket Proprietary & Confidential Information
E-mail: [e-mail] Website: http://www.alinket.com
28
To satisfy FCC RF Exposure requirements for this transmission devices, a separation distance of 20cm
or more should be maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this distance is not recommended. The antenna(s) used
for this transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number：
(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is installed
must also display a label referring to the enclosed module. This exterior label can use wording such
as the following: “Contains Transmitter Module FCC ID:2AELJ-ALXCOMBO.” Any similar wording that
expresses the same meaning may be used. The Grantee may either provide such a label, an example
of which must be included in the application for equipment authorization, or, must provide adequate
instructions along with the module which explain this requirement. In the latter case, a copy of these
instructions must be included in the application for equipment authorization.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.