User's Manual

IMPORTANT:
1) Avoid “Oily” locations.
2) Don’t place above or near a heat source which may cause the equipment to overheat.
3) Microwave ovens can cause interference and diminish the quality of the signal if the mini TX or receiver is located close by.
4) Beware of humid locations. Water droplets or spray may damage the units. If condensation does occur,
do not use until the equipment has dried out.
5) Do not use in temperatures exceeding 55 degC.
6) Never paint or attach metallic labels and sticker of any kind.
7) Do not use two transmitters and receivers operating at the same time in the same area.
This will result in picture and sound interference.
SPECIFICATIONS:
Mini Video Camera Transmitter:
1) Frequency: One channels in 2.4 GHz frequency band
2) RF output power: FCC compliant
3) Transmitter range: 100 meters in L-O-S
4) Modulation: FM
5) Operating power: DC5V – 12V
6) Power consumption: 80mA
7) Antenna: Omni-directional integrated antenna
8) Size: 22.5 x 26.5 x 18mm
9) Temperature: -10 to +55 degC
Color CMOS Camera:
10) Pixels: 365K (PAL), 250K(NTSC)
11) Auto Electronic Exposure: 1/60 – 1/15000 sec.
12) Automatic Exposure/Gain/White balance
13) Mini. Illumination: <3 Lux@1.2
14) Pinhole Lens: f=5.6mm/Field angle: 60 deg. (Diagonal)
“A” type: F/2.0mm, f= 5.6mm/View angle: 60 degrees
“B” type: F/2.0mm, f= 3.8mm/View angle: 90 degrees
Receiver:
1) Frequency: Four channels in 2.4 GHz frequency band
2) Video input/output: 1Vp -p/75 ohm
3) Audio input/output: 0.8V/600 ohm
4) Antenna: 60 degree directional antenna
5) Audio bandwidth: 50 –17000 Hz
6) Operating power: DC12V
7) Power consumption: 180mA
8) Size: 150x88x40mm
TROUBLE SHOTTING:
1) Poor picture and sound: Realign antennas, slightly adjust the position of the Mini TX or receiver.
2) Line only-no picture: Check to confirm there is no microwave oven or other 2.4 GHz equipment operating close by.
3) Picture ghosting: Check for interference caused by obstacles such as trees, buildings and shrubs, etc.
Select new transmitter and /or receiver site.
4) No picture: Check the receiver to confirm it is turned “ON” and make sure the A/V connection of the RX is not
plugged the wrong way around.
Notice: The changes or modifications not expressly approved by the party responsible for compliance Could void the user’s
authority to operate the equipment.
Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device
is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements
and void User’s authority to operate the device.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE, MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNESRIED OPERATION.