Installation manual

10/3/2012 601-900-3224-INST
12
Troubleshooting
If you experience problems after installation, there is a simple test to help diagnose the problem. Simply
unplug the wiring harness from the back of the Co-Pilot and put a bent paperclip into blue and yellow
terminals of the harness’ plug (jumper the blue and yellow together). This reconnects the wire that
you cut at the transmission plug and bypasses the Co-Pilot completely.
If your pickup behaves normally after bypassing the Co-Pilot: Make sure you are following the
operating instructions correctly and that all wire connection are good and to the proper wires. If
the problem continues, contact our Technical Support department at [e-mail] or
800-949-6002.
If the problem continues after bypassing the Co-Pilot: There is a problem with a wire connection.
Double-check all connections. Make sure your solder connections are good, if any look suspect,
re-solder. Make absolutely sure that all taps were made on the correct wires. Some of these
wires can be easily confused with neighboring ones especially if the connection was made away
from the plug, inside the wiring harness. If the problem continues, contact our Technical
Support department at [e-mail] or 800-949-6002.
Have Any Questions?
Thank you for purchasing the ATS Co-Pilot. Please check our website at http://www.atsdiesel.com for
technical support and other performance products such as the 5-Star™ torque converter, ATS Valve
Body and ATS Transmission along with our full line of products please call or e-mail our Technical
Service Department, 8:00am to 5:30pm Mountain Standard Time, Monday through Friday.
Contact Information
Toll Free: 800-949-6002
Local: 303-431-7973
Fax: [phone]
Website: www.ATSDIESEL.com