User`s guide

PC*MILER-AS400 User’s Guide 125
Appendix L: Running PC*MILER and PC*MILER|Tolls Builds
of the AS400 Interface on the Same PC
These instructions are intended for use if you are required to run a Tolls build and a
Non-Tolls build of the PC AS400 Interface (Srv32.exe, also known as ‘Bart’) on the
same PC. Where noted, this method can also be used if you need to run two AS400
Interfaces connected to two different AS400s.
Background
With the purchase of the optional PC*MILER|Tolls module, you will have two separate
builds of the PC AS400 Interface installed (Srv32.exe and Srv32_Tolls.exe or
Srv32_Hwy.exe).
You will be making copies of two files used by the AS400 Interface, copying and editing
your existing shortcut, and changing the Library= value in the appropriate INI file
(Change System=, User=, and Pass= values for dual AS400 configurations).
There are two types of shortcut or command line properties available to start your PC
AS400 Interface:
C:\ALK Technologies\pcmiler28\AS400\Srv32.exe 1 2 2
and
C:\ALK Technologies\pcmiler28\AS400\Srv32.exe 2 2 2
With 1 2 2, srv32.exe will link to C:\windows\pcmsrv32.dll and pcmserve.ini while 2 2 2
will link to c:\windows\pmwssrv.dll and pmwssv.ini.
After installing, you will have one of these configurations as a starting point:
Case 1: PC*MILER Highway Only with PC*MILER Build of Bart - Parameters 1 2 2
Case 2: PC*MILER Highway Only with PC*MILER|Tolls Build of Bart - Parameters 1 2 2
Case 3: PC*MILER|Streets with PC*MILER Build of Bart - Parameters 2 2 2
Case 4: PC*MILER|Streets with PC*MILER|Tolls Build of Bart - Parameters 2 2 2
Case 5: Adding second Bart to service second AS400
Your Srv32.exe will either be a PC*MILER Build or a PC*MILER|Tolls Build, you must
check Srv32.exe’s file properties to determine the build that was installed.
See Steps 1 – 3 on the following pages.