User's Manual

1600 PSI Pressure Washer
9
OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE WASHER!
Starting Up
After connecting the pressure washer to your cold
water supply, proceed as follows:
- Make sure that the on/off switch is
in the off position.
- Connect the garden hose with quick
connect to the inlet fitting.
- Attach the hose to the gun as per
assembly instruction step #1.
- Insert the adjustable spray nozzle
into the gun as per assembly step
#2.
- Connect the high pressure hose to
the high pressure outlet fitting as
per assembly step #3.
- Open the water supply valve completely.
- Before turning the unit on, press the gun trigger to bleed all the
remaining air out of the pump and hose.
- Start the pressure washer by turning the on/off switch to the
on position and squeeze the trigger.
REMINDER: Motor does not run continuously, only when the trigger is squeezed.
WARNING – RISK OF INJECTION! Unit will start spraying
when trigger is squeezed. When turning the unit off after
use, high pressure still exists inside the hose and unit. Point
the gun in a safe direction and discharge the excess
pressure. NEVER direct the high pressure water stream at
people or animals.