Technical data

18 • The WAGO-I/O-SYSTEM 750

Mechanical Setup

WAGO-I/O-SYSTEM 750

CC-Link

2.5.9 Wire connection

All components have CAGE CLAMP® connections.

The WAGO CAGE CLAMP® connection is appropriate for solid, stranded

and fine–stranded conductors. Each clamping unit accommodates one con-

ductor.

Fig. 2-9: CAGE CLAMP® Connection g0xxx08x

The operating tool is inserted into the opening above the connection. This

opens the CAGE CLAMP

. Subsequently the conductor can be inserted into

the opening. After removing the operating tool, the conductor is safely

clamped.

More than one conductor per connection is not permissible. If several con-

ductors have to be laid at a connection, then they should be laid in off-course

wiring; e.g. together with WAGO transfer terminals.

Attention

If it is unavoidable to jointly connect 2 conductors, then a ferrule must be

used.

Ferrule:

Length 8 mm

Nominal cross section

max.

1 mm

for 2 conductors with 0.5 mm

each

WAGO Product 216-103

or products with comparable properties