Manual

Compressor(cont'd)

Assembling the Compressor (cont'd)

1 Pc. 1/4° NPT Air nozzle with trigger

1 Pc. 1/4" x 25' Recoi_ Air Hose

1 Pc. 1/4" NPT Quick. Coupler

3 Pc, 1/4_NPT Thread

Connectors ! M

I Pc" 1/4° NPT Thread _ ;

Connectors / F _ _

1 Roll Teflon sealant thread tape

2 Tighten the handle into its position

with screws included,

3 Check the compressor's serial label to ensure that you have re_ived

the model ordered, and that it has the required pressure rating for its

intended use.

4 Locate the compressor according to the following guidelines:

a Position the compressor near a grounded electrical outlet (see

GROUNDING INSTRUCTIONS, above).

b The compressor must be at least 12 inches (31 cm) from any wall or

obstruction, in a clean, weIFventilated area, to ensure sufficient air

flow and oooling.

c in cold climates, store portable compressors in a heated building

,when not in use. This will reduce problems with motor starting and

freezing d water condensation.

d Remove the compressor from the shipping pallet or carton and place

it on the floor or a hard, level surface. The compressor must be level

to ensure proper drainage d the moisture in the _nk.

5 Connect an air hose to the _mpressor hose outlet.