Manual

AirCompressor

Compressor(cont'd)

ElectricalPowerRequirements(cont'd)

This product is for use on a nominal 115 volt circuit. An outlet with a

grounding plug must be used.

Make sure that the product is connected to an outlet having the same

configuration as the plug. No adapter should be used with this product.

BreakingIn the Pump

Turn the pressure switch to the OFF position.

Open the petcock. Turn counterclockwise.

Plug in the power cord.

Turn the power switch to the ON position. The compressor will start.

Allow the compressor to run for 15 minutes, to break in the internal

parts.

CAUTION: AFTER ABOUT 15 MINUTES. IF THE UNIT DOES

NOT OPERATE PROPERLY. SHUT DOWN IMMEDIATELY.

AND CONTACT PRODUCT SERVICE.

5 After about 15 minutes, turn the power switch to the OFF position.

6 Close the petcock. Turn in the clockwise direction

7 Turn the power switch to the ON position. The compressor will start

and fill the tank to the kick-out pressure and stop.

_ ote: As compressed air is used, the pressure switch will restart

the motor automatically.

_ ote:During the initial break-in cycle, there will be a slight

electrical smell as the motor brushes seat. This is normal for

universal motors and will last for about 5 minutes.