Manual

Owner'sManual
Troubleshooting(cont'd)
Excessivestartingandstopping,whilenotin
use
• Fittings leak
Check fittings with soapy water. Tighten or reseal leaking fittings. DO
NOT OVERTIGHTEN.
Replace worn parts and reassemble with new seals.
Replace any faulty seals.
• Air leaks from regulator, or regulator does not regulate pressure
Dirty or damaged regulator internal parts.
Replace regulator or internal parts.
• Regulated pressure gauge reading drops when air accessory isbeing
used
This is normal
Compressor not large enough
If pressure drops too low, adjust regulator while accessory is used.
Check air requirement of accessory. If it is higher than CFM and I
pressure supplied by compressor. Most accessories are rated at
25% of actual CFM while running continuously.
Circuit breakertrips (fuseblows)too often
• Low voltage
Consult electrician.
• Excessive wire length
Furnish adequate power. If using extension cord, try without.
• Restricted air passages
Contact authorized service center.
• Back pressure in pump head
Replace check valve, pressure switch bleeder valve.
24