Use and Care Manual

28
Installation (contd)
Connect a #6 AWG grounding wire (not included) from the ground
connector on the generator to a grounding rod (not included) that
has been driven at least 24 inches deep into the earth. The grounding
rod must be an earth-driven copper or brass rod (electrode) which can
adequately ground the generator.
6000W Generator
Brass Rod (electrode)
Ground Connector
WARNING! THE GENERATOR WEIGHS APPROXIMATELY 189 POUNDS. USE
CARE AND THE PROPER LIFTING OR HOISTING EQUIPMENT WHEN MOVING
IT TO THE INSTALLATION LOCATION. ALWAYS CONNECT HOIST LINES TO
THE FRAME OF THE GENERATOR.
General Location
Make sure to locate and install the generator outdoors where cooling air is readily available.
Install the generator so that the air inlets and outlets are not blocked by obstructions such as
bushes, trees, or snow drifts. Locating it in the path of heavy wi
nds or snowdrifts may require
the placement of a barrier for protection. In normal weather conditions, the air vent should face
the prevailing wind direction.
Install the generator on a concrete slab or other area where rain drainage or flood waters can
not reach it.
Generator placement should allow four feet of access to all sides for maintenance.
Place the generator as close as possible to the electrical tools and equipment being powered to
reduce the length of extension cords.
Supporting and Mounting
Mount the generator on a concrete slab capable of supporting the weight of the generator. The
slab must extend on all sides beyond the frame by at least one foot.
Contact a cement contractor for slab specifications if necessary.
Attach the frame to the concrete slab using 3/8” diameter expansion
anchor bolts (not supplied).
Grounding
NOTE: IT IS RECOMMENDED THAT ONLY A
TRAINED AND LICENSED ELECTRICIAN PERFORM
THIS PROCEDURE
Electrical and other permits may be required for the installation of emergency power systems.
Investigate your local building and electrical codes before installing this unit. Installation must be
completed by licensed contractors.