Use and Care Manual

6000W Propane Generator

Operation (cont’d)

Powering 120 Volt AC Tools And Equipment:

1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage

capacity (120V AC @ 42 AMPs) is adequate to supply all electrical loads that the unit will

power. If powering exceeds the generator’s capacity, it may be necessary to group one or more

of the tools and/or equipment for connection to a separate generator.

CAUTION: ATTEMPTING TO POWER SENSITIVE ELECTRONIC EQUIPMENT

WITHOUT THE USE OF AN APPROVED LINE CONDITIONER MAY CAUSE

DAMAGE TO THE EQUIPMENT. ALL-POWER IS NOT RESPONSIBLE

FOR ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE TO USE AN

APPROVED LINE CONDITIONER.

2. Once the generator is running, simply connect the power cords of 120 volt AC powered

tools and equipment into the 120 volt AC dual outlets.

3. Disconnect all electrical powered tools and equipment from the generator’s 120 volt AC

duel outlets.

4. After the engine and generator have completely cooled, store generator in a safe, clean, dry

location (if not already installed).

NOTE: THE GENERATOR FEATURES AN AC NON-FUSE CIRCUIT BREAKER TO

PROTECT THE AC CIRCUIT IN CASE OF AN OVERLOAD. SHOULD AN OVERLOAD

OCCUR, THE BREAKER WILL “TRIP” TO ITS “OFF” POSITION.

For 120/240V Output

According to the diagram on the panel, you can adjust the wiring to have the output you need.