Product specifications

5.
Battery i37): The power source for the Impact Wrench is a rechargeable,
5.
Verify that the RED Charging Indicator Ught comes on. If it does not iliuminate,
19.2VDC Battery. Make sure to follow all safety precautions when working with the
check the power connection or try a different electrical outlet. Charge the Battery
Battery.
(See Figure D.)
(37) for 1 hour. NOTE: When the Battery is fully charged the RED Charging
Indicator
Light WIH turn off, and the GREEN Charged L~ght will illuminate. Subse-
6. Charger (39): The Charger is powered by plugging its Power Plug into a 120 volt,
quent
charglng can also be done in 1 hour. (See Figure D.)
grounded, electrical outlet. NEVER attempt to power the Charger wlth any other
electrical source other than a
120 volt, grounded electrical outlet. (See Figure D.)
6.
While charging, the Battery (37) and Charger (39) may become warm to the touch.
Thls is normal, and does not lndicate a problem. (See Figure D.)
CONNECT TO
ELECTRICAL
FIGURED
TO CHARGE THE IMPACT WRENCH
1.
NOTE: The Battery (37) requires charging. The first charge requires 1 hour
c'harge time prior to using the Impact Wrench. (See Figure D.)
2. The Battery (37) should only be recharged when the lrnpact Wrench begins to
run slowly.
(See Flgure D.)
3.
When the Battery (37) requires recharging, a 1 hour charge allows the tool to
operate
at full power. Do not recharge the Battery lonaer than 1 hour, as darna~
to the Battery and/or Impact Wrench will occur. {See Figure 0.)
4.
Make sure the Trigger (36) on the lmpact Wrench rs In its "OFF' position. Slide
the Battery
(37) oft the handle of the lmpact Wrench. Insert the Battery into the
charglng socket of the Charger (39). Then plug the Charger !nto the nearest 120
volt, grounded, electrical outlet. (See Figure D.)
7.
Once the Battery (37) is fully charged, disconnect the Charger (39) from the
electrical outlet. Remove the Battery from the Charger, and insert the Battery
into the handle of the Impact Wrench.
(See Figure 0.)
8.
NOIE If charging more than one Battery (37), allow the Charger (39) to cool
down before
reusing. (See Figure D.)
I OPERATING INSTRUCTIONS I
I.
Before installing a socket, make sure the Battery (37) is removed from the lmpact
Wrench to
avold accidental starting. Then, firmly insert the Socket onto the 112"
lmpact Mead (7) of the tool. (See Figure D.)
2. Whenever possible, secure the workpiece in place, using a vise or clamps (not
included).
3, Insert the fully charged Battery (37) into the handle of the Impact Wrench.
(See Figure D.)
4.
Use the Forward/Reverse Switch (32) to select the turning rotation of the lmpact
Wrench.
(See Figure D.)
5,
Insert the socket onto the nut that is to be loosenedhightened
6.
Make sure to hold the Impact Wrench firmly wlth both hands, as torque from the
Motor will cause the
tool to twist. Then, squeeze the Trlgger (36) to turn on the
lmpact Wrench. (See Figure D.)
7. When finished, release the Trigger (36) to stop the Impact Wrench. Then, re-
move the Battery
(37) and socket from the tool. (See Figure D.)
8.
Make sure to store the lmpact Wrench in a dry, clean location out of reach of
chlldren and other unauthor~zed people.
Page 8 Page 9